Issue I348 [80,gui,med,resolved] View Variables tab list cut off and not updated in display. Reported by dfry-20061224 Description: The View Variables tab list sometimes gets cut-off on the bottom in its display. This is a display problem. The problem is fixed in 8.0.2. A quick workaround if this occurs in 8.0.0-8.0.1 is to switch to the Hide tab and then back to the Variables tab. Also, variable list display wasn't updating at the end of Fly'm (e.g. if user changes variables during Fly'm). To reproduce: Example #1 Load quad.iob. Select Variables tab and enable Show All. Switch to Workbench tab and then back to Variables tab. Note: variables list is cut-off. This can be corrected though with this workaround: Select Hide tab and then Variables tab (or check and uncheck Show All). Example #2: Load trap.iob. Switch to Variables tab. All variables display. In Particles tab, click Define.... Then Cancel. Switch to Variables tab. Variable list is cut-off. This can be corrected by the same workaround given above. Example #3: Load trap.iob. Switch to Variables tab. All variables display. Switch to Workbench tab and back to Variables tab. Do this twice. Variables list is cut-off. This can be corrected by the same workaround given above. Original note by dfry-20061224: (2) The first time I go into the workbench I can see the adjustable variables. If I exit and go back into the workbench the variables list is reduced to maybe one or two out of 5 or 6 variables. http://www.simion.com/discuss/viewtopic?p=1231 Affects: 8.0.0-8.0.1 NOT Resolved: 8.0.2 Reopened (20070808) since this still affects 8.0.3 if "Show All" is clicked with quad.iob loaded. Resolved in 8.00.4-TEST25.